Choose ValvesOnly, a leading valve manufacturer in the USA, for superior valves for your industrial operations across North America
Table Of Contents
Valvesonly are the best Foot Valve Manufacturers in USA. A foot valve is a type of check valve that is typically installed at the bottom of a vertical pipe or pump suction line. Its primary function is to prevent the backflow of fluid from the discharge line back into the pump or sump when the pump is not operational. The valve consists of a body with an inlet port, an outlet port, and a flap or disc that opens to allow fluid to flow into the pump when it is operating and closes to prevent backflow when the pump is turned off.
How Foot Valve works?
The operation of a foot valve is relatively simple. When the pump is turned on, it creates suction that draws fluid through the valve and into the pump. As fluid enters the valve, the pressure from the incoming flow pushes the flap or disc open, allowing the fluid to pass through and into the pump. When the pump is turned off, the pressure differential changes, causing the flap or disc to close under its own weight or with the help of a spring, thus preventing the fluid from flowing back into the suction line. This ensures that the pump remains primed and ready for operation when needed, without the risk of losing prime due to backflow.
How to install foot valve?
Choose a suitable location in the water source (such as a well, lake, or reservoir) where you want to draw water from. Ensure that the location is accessible for maintenance purposes.
Before installing the foot valve, prepare the pipeline by cleaning the pipe ends and removing any debris or obstructions that could interfere with the valve’s operation.
Set the correct orientation for installing the foot valve. The valve should be installed at the bottom of the suction pipe, with the inlet facing downward to allow water to flow into the valve.
Attach the foot valve to the suction pipe using appropriate fittings or couplings. Ensure that the valve is securely fastened to prevent leaks or movement during operation.
Double-check that the foot valve is installed in the correct orientation, with the inlet facing downward and the outlet connected to the suction pipe leading to the pump.
If necessary, prime the pump to remove any air from the system and create a vacuum that will allow water to be drawn into the suction pipe and foot valve.
Once the foot valve is installed, test its operation by activating the pump and monitoring the flow of water. Check for any leaks or abnormal noises that could indicate a problem with the installation.
How to test Foot valve?
By following these steps, you can effectively test a foot valve to ensure proper operation and reliability in your pumping system.
Before testing the foot valve, visually inspect it for any signs of damage, corrosion, or wear. Check the valve body, sealing surfaces, and connections for leaks, cracks, or other defects.
Start the pump and observe the flow of water through the suction line. The foot valve should open automatically, allowing water to enter the suction line and pump.
Monitor the pressure gauge on the pump to ensure that it builds up to the desired level. If the pressure does not increase or remains low, it could indicate a problem with the foot valve or suction line.
While the pump is running, inspect the foot valve and surrounding connections for any signs of leaks or abnormal behavior. Leaks could indicate a faulty seal or loose connection that needs to be addressed.
Once the test is complete, turn off the pump and observe the behavior of the foot valve. It should close automatically to prevent water from flowing back into the suction line.
If any issues were identified during the initial test, repeat the testing process after addressing the problem to ensure that the foot valve functions properly.
ValvesOnly are trusted Foot Valve Manufacturers in USA and we offer excellent customer service and consultation. If you’re considering installing a foot valve horizontally, it’s advisable to consult with the manufacturer or a qualified technician to ensure that the chosen valve is suitable for horizontal installation and to receive guidance on proper setup and maintenance procedures.
Description:
Available Materials: SS304, SS316, Cast Iron and Ductile Iron, WCB
